1. Operating procedures

As the brain of the automatic lubrication system, the controller makes the system realize automatic work and intermittent time setting. The buttons of the program controller are "manual" and "stop". When it is necessary to start, press the "manual" button for one second, the controller sends signals to the main oil pump, the running light is on, and the system completes the action of refueling. When there is a fault, press the "stop" button to clear the fault light and alarm sound. In the process of normal operation, if you press the "stop" button, you can also stop oil drilling; When setting the time, the Manual button is displayed in ascending order and the Stop button is displayed in descending order.

2. Set the time

At the same time, press the "manual" and "stop" three seconds into the setup time, set up the lights, digital tube display "t1", interval of 5 seconds after the digital tube display "XX" as the system of the intermittent time, press the "manual" at this time can make increasing time in minutes, the maximum is 999 points, press the "stop" button to decrease the time in minutes, After the interval is set, the nixie tube displays "t3" after 5 seconds, and the nixie tube displays "YYY" for the system working time after 5 seconds. At this time, press the "manual" button to make the time increase by seconds, the maximum value is 999 seconds, and press the "stop" button to make the time decrease. "t5" is the unloading monitoring time setting. Non-professionals cannot change the factory setting. After the setting is complete, the setting indicator turns off.

3. How you work

Controller in the digital tube display the countdown time after turning on the power supply, displayed in a minute, let the system standby), passive standby system, to set the time signal action make the system run, can also according to the actual need to manually go at any time, every time after the completion of the manual system clock will start again;

The system has a memory function, that is, the last time the timing did not reach an intermittent cycle, in the next vehicle driving accumulates, full of a cycle action.

4. Display function

(1) Energizing the digital tube to the controller shows that the countdown time is in decreasing order, indicating that the system is in standby state;

(2) When the system is running, the digital tube circulates in a ring, and the running light is on, indicating that the system is in the running state;

(3) In the process of system operation, pressure signal is detected, and the normal light is on; When there is a fault phenomenon, the fault light should be on and the alarm sound should be issued.